top of page
Note: This site is not optimised for mobile and is best experienced in desktop view.
DIY Travel Cage
You Will Need
-
A small, clear container with a secure clip-on lid.
-
4 bolts.
-
4 nuts.
-
Washers (optional)
-
A piece of wire mesh slightly smaller than the lid.
-
A drill.
-
A sharp craft knife for cutting plastic.
Step 1.
Use the craft knife to cut a large square hole in the lid of the box. Be very careful and cut slowly so as to avoid cracking the lid.
Step 2.
Carefully drill 4 holes in the lid, one in each corner.
Step 3.
Push the bolts through the holes so they are facing inwards. Place the mesh over the top and screw the nuts tightly onto the bolts.
(You may wish to use washers on either side of the mesh)
Finished!
Place the lid back onto the cage and you are finished.
bottom of page